BD Heavy Duty Trackmaster Transmission - Dodge 2005-2007 4WD 48RE

• Clutch Count: OD 6
• Clutch Count: OD DIRECT 10
• New input shafts and hub
• Fully rollerized geartrain all thrust washers replaced with bearings
• Pan adds 1qt extra oil capacity
• New design full manual valve body
• Up to 80% higher clutch apply pressures over the stock unit
• Pressure increase starts at much lower engine rpm's and at lighter throttle pedal position movement
• Light throttle shift firmness is also maintained
• No shuttle shifting problems
• No 48RE 2-3 shuttle issue
• Upgraded governor pressure transducer (47RE/48RE)
• Upgraded governor solenoid - Twice the burst pressure than stock
• Cooler line case saver in every transmission
• Added heavy-duty clutches with up to 25% more material than stock
• Machined forward (rear) beveled pressure plate
• Machined overdrive brake (front & rear) pressure plate
• Machined direct clutch (front) piston
• Machined front ring gear
• High temp/energy Raybestos band
• Rigid intermediate band
• Billet band strut & anchor
• Billet dual ring accumulator piston
• Billet dual ring kickdown servo
• Billet front drum
• Billet output shaft
• Billet intermediate shaft drilled for increased lube
• Billet "Big" fine spline input shaft
• New stator support shaft
• Stock thrust washers replaced with roller Torrington bearings
• BD auxiliary full flow filter kit for extra protection
• Clutch Count: FORWARD 5
• Clutch Count: DIRECT 6
• BD rigid aluminum heavy duty transmission pan
• Pan reduces case flex
• Pan reduces internal oil leakage
• Pan heat-dissipating fins keep temperature down
• Pan magnetic drain plug
• Each transmission is dyno tested

Warranty

Parts

• 12-Months
• 24,000 Miles

Note

• BD torque converter must be installed at the time of installation of the transmission - use of a 3rd party or OE converter will invalidate the transmission warranty
• "Big" fine spline converter required